Copyright 2014 Digi InternationalĪ Beginner’s guide to send data to Device Cloud from a ZigBee Network Set the same PAN ID that you have used to create a ZigBee network. There can be only one coordinator in a ZigBee network, which is Connect Port gateway in this case. If so, load modules with Router or End Device firmware (ZigBee Router AT recommended). Make sure that module is not acting as Coordinator. Open XCTU and select appropriate COM port to load module’s current configuration. The above step will initiate a ZigBee network with the specified PAN ID.Ĥ.2 Configuring XBee module Place XBee module on Digi’s XBIB Dev board and connect to PC.
Enter appropriate Extended PAN ID (ID) parameter and click “Apply” button at end. Select Coordinator from Network View of XBee Devices. In Gateway’s Web UI, navigate to XBee network->Configuration. You can find gateway using Digi’s “Device Discovery” Tool (refer section 8).
It does not teach Python Programming.Ĥ Setting up network between XBee and gateway 4.1 Configuring gateway Plug in your ConnectPort gateway to network and accessing its Web UI using appropriate IP address. This application note applies only to ZigBee or DigiMesh network of module(s) and Connect Port X2/X4/X2e gateway.ģ.3 Assumptions This document assumes that devices are set to their factory default configurations.ģ.4 Scope This document will cover aspects of setting up a network for data transmission to Device Cloud using a Python Script. 12ģ Introduction 3.1 Outline A getting stated guide for people to create basic setup for sending data from a ZigBee network to Etherios Device Cloud.ģ.2 Audience This guide has been written for users with a basic understanding of XBee modules, Digi ConnectPort gateways and Etherios Device Cloud. 4 Setting up network between XBee and gateway. A Beginner’s guide to send data to Device Cloud from a ZigBee Networkĭocument History.